Set freze pentru rectificat scaune de supape 28-75mm
SEAPIDStare
DA27433601
Data19 Februarie 2021
Valoare2.694,12 RON
Oferta acceptata
Autoritatea contractantaLocalitateCluj-Napoca, Cluj
FurnizorTipul contractuluiFurnizare
Cod CPVDescriere:Conform raport de urgenta atelier auto
Achizitii2.694,12 RON
Cantitate: 1
Unitate masura: bucata
Set freze pentru scaune de supape 28-75mm, 15 piese
Descriere:
- potrivite pentru capetele cilindrilor cu scaune de supapa intarite
- include:
- 6 freze fata-verso
d 28 - 37 mm, 45 / d 28 - 37 mm, 75
d 28 - 37 mm, 30 / d 37 - 44 mm, 75
d 37 - 46 mm, 45 / d 37 - 46 mm, 60
d 37 - 46 mm, 30 / d 44 - 52 mm, 75
d 46 - 60 mm, 30 / d 46 - 60 mm, 45
d 52 - 65 mm, 60 / d 52 - 65 mm, 75
- 4 ghidaje reglabile continuu
pentru d 6,5 pana la 12,5 mm
- T-Maner pentru freze
GENERAL Due to the hardness of the valve seats, they have to be processed with special milling cutters. The milling cutter set includes the most needed milling cutters for the seating, a milling cutter for the upper and a milling cutter for the lower correction angle. The objective of processing the valve seats is to clean the sealing surface to adapt one of the seats to the dimensions required by the vehicle manufacturer. Because of the sealing the valve seat may not be too wide, and because of good heat transfer not too narrow. NOTES ON SAFETY During milling always wear a respiratory protection mask which prevents any inhalation of abrasion deposits e.g. coking, carbon deposits etc.. In case of utilization of compressed air for cleaning, always wear protective goggles in addition. Always note the recommendations of the vehicle manufacturer. Information about valve seating width etc. can be taken from vehicle-specific service literature. Processing of valve seats should be carried out by a trained specialist only.