Set freze pentru scaune de supape 28-75mm, 15 piese

    SEAP
    ID
    DA24427849
    Data
    19 Noiembrie 2019
    Valoare
    2.521,01 RON
    Stare
    Oferta acceptata
    Autoritatea contractanta
    2749993 - REGIA AUTONOMA JUDETEANA DE DRUMURI SI PODURI
    Localitate
    Constanta, Constanta
    Furnizor
    5439849 - S.C. SERVICE INCLUS SRL
    Tipul contractului
    Furnizare
    Cod CPV
    44511000-5 - Scule de mana (Rev.2)
    Descriere:
    Freze pentru rectificat scaun supape BGS - 68346 CU CARBURA Wolfram
    Achizitii
    2.521,01 RON
    Cantitate: 1
    Unitate masura: bucata
    Set freze pentru scaune de supape 28-75mm, 15 piese
    Descriere: - potrivite pentru capetele cilindrilor cu scaune de supapa intarite - include: - 6 freze fata-verso d 28 - 37 mm, 45 / d 28 - 37 mm, 75 d 28 - 37 mm, 30 / d 37 - 44 mm, 75 d 37 - 46 mm, 45 / d 37 - 46 mm, 60 d 37 - 46 mm, 30 / d 44 - 52 mm, 75 d 46 - 60 mm, 30 / d 46 - 60 mm, 45 d 52 - 65 mm, 60 / d 52 - 65 mm, 75 - 4 ghidaje reglabile continuu pentru d 6,5 pana la 12,5 mm - T-Maner pentru freze GENERAL Due to the hardness of the valve seats, they have to be processed with special milling cutters. The milling cutter set includes the most needed milling cutters for the seating, a milling cutter for the upper and a milling cutter for the lower correction angle. The objective of processing the valve seats is to clean the sealing surface to adapt one of the seats to the dimensions required by the vehicle manufacturer. Because of the sealing the valve seat may not be too wide, and because of good heat transfer not too narrow. NOTES ON SAFETY During milling always wear a respiratory protection mask which prevents any inhalation of abrasion deposits e.g. coking, carbon deposits etc.. In case of utilization of compressed air for cleaning, always wear protective goggles in addition. Always note the recommendations of the vehicle manufacturer. Information about valve seating width etc. can be taken from vehicle-specific service literature. Processing of valve seats should be carried out by a trained specialist only.